Datalogic AMT58 Series Manual page 155

AMT58x-EC EtherCAT®
100A-00 Software version
[String, ro]
It shows the software version of the device.
1010-01 Store parameters
[Unsigned32, rw]
Use this object to save all parameters on the non-volatile memory.
Write "save" in ASCII code in the data bytes:
Master Encoder
Cmd Index
23 10 10
Encoder Master (confirmation)
Cmd Index
60 10 10
1011-01 Restore default parameters
[Unsigned32, rw]
This object allows you to restore all parameters to default values.
The default parameters are set at the factory by Datalogic
Automation engineers to allow the operator to run the device for
standard operation in a safe mode. A list of machine data and
relevant default parameters preset by Datalogic Automation s.r.l.
engineers is available on page 56.
Write "load" in ASCII code in the data bytes:
Master Encoder
Cmd Index
23 11 10
Encoder Master (confirmation)
Cmd Index
60 11 10
NOTE
To save the default values execute the "Store parameters" function
(see object
1010-01 Store
off, parameters not saved are lost.
46
Cmd specific data
Sub
01 73 61
Cmd specific data
Sub
01 00 00
Cmd specific data
Sub
01 6C 6F
Cmd specific data
Sub
01 00 00
parameters). When the power is turned
Data
76 65
Data
00 00
Data
61 64
Data
00 00