Safety Summary - Datalogic AMT58 16x14 PB Series Instruction Manual

1. Safety summary

 Always adhere to the professional safety and accident prevention
regulations applicable to your country during device installation
and operation;
 installation and maintenance operations have to be carried out by
qualified personnel only, with power supply disconnected and
stationary mechanical parts;
 device must be used only for the purpose appropriate to its design:
use for purposes other than those for which it has been designed
could result in serious personal and/or the environment damage;
 high current, voltage and moving mechanical parts can cause
serious or fatal injury;
 warning ! Do not use in explosive or flammable areas;
 failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design,
manufacture, and intended use of the equipment;

Datalogic Automation S.r.l. assumes no liability for the customer's
failure to comply with these requirements.
 Turn off power supply before connecting the device;
 connect according to explanation in section "4 – electrical
connections";
 in
compliance
electromagnetic
must be taken:
- before handling and installing, discharge electrical charge from
your body and tools which may come in touch with the device;
- power supply must be stabilized without noise, install EMC filters
on device power supply if needed;
- always use shielded cables (twisted pair cables whenever
possible);
- avoid cables runs longer than necessary;
- avoid running the signal cable near high voltage power cables;
- mount the device as far as possible from any capacitive or
inductive noise source, shield the device from noise source if
needed;
- to guarantee a correct working of the device, avoid using strong
magnets on or near by the unit;
- minimize noise by connecting the shield and/or the connector
housing and/or the frame to ground. Make sure that ground is not
affected by noise. The connection point to ground can be situated
both on the device side and on user's side. The best solution to
minimize the interference must be carried out by the user.
Safety
Electrical safety
with the 2014/30/EU
compatibility, following
AMT58x-PB Profibus®
norm on
precautions
1