D35 Electronics Error - Bayer HealthCare RapidPoint 400 Series Service Manual

Message
D35 Electronics
Error: 1-13
Qualifiers:
1 DAS error
2 Signal processing
error
4 -12V out of range
5 +12V out of range
6 +24V out of range
7 24V power control
error
9 System noise error
10 Main board error
11 DAS bus error
13 Pump motor error
D35 Electronics
Error: 14
Qualifier:
14 Door lock
D35 Qualifier Descriptions
D35 occurs during power-up initialization (PUI), before calibrations, or
during an MIT (manually initiated test). A D35 error indicates an electronics
hardware failure.
Qualifiers 1, 2, 4, 5, and 9 occur during PUI before calibrations.
Qualifiers 6 and 7 occur during PUI only.
196
Probable Cause and Corrective Action
An error has occurred in the electronic components.
1. When prompted, shut down the system as described in
Shutting Down the System on page 256, wait 10 seconds,
and then turn the system on.
2. If the message appears again, record the message,
including the qualifier, and call for technical assistance.
Service Solutions
Perform service solutions only after all other corrective
actions have been completed.
1. Perform the test to measure the 5 volt supply. Refer to
Replacing the Main Board, in Replacing Components.
2. Check all cables and connections.
3. If a D35: 2 or 9 occurs, check the ground on the front door,
replace the cartridge interface module.
4. Replace the Main board.
The system detects a problem with the door.
1. Ensure that nothing is blocking the door from opening.
2. When prompted, shut down the system as described in
Shutting Down the System on page 256, wait 10 seconds,
and then turn the system on.
3. If the message appears again, record the message,
including the qualifier, and call for technical assistance.
Service Solutions
Perform service solutions only after all other corrective
actions have been completed.
1. Test the door using the
2. Check cable connections.
3. Replace the door lock assembly.
button in Diagnostic tests.
Door
Rev. C