Bayer HealthCare RapidPoint 400 Series Service Manual page 393

8. Touch
Setup
your system. Refer to Defining the Rapidpoint 400 Series System
Setup, Section 6 in the Rapidpoint 400 Series Operator's Manual.
a. Enter the default password,
b. When you finish the Setup options, touch the
The system displays the Status screen and a message indicating
that the measurement cartridge needs replacing.
9. Touch
Replace
The system plays a video that shows how to replace the cartridges.
10. View the video before you begin. Observe the steps for installing new
cartridges.
11. Install the measurement and wash/waste cartridges:
Refer to Replacing the Measurement and Wash/Waste Cartridges in
Section 3 in the Rapidpoint 400 Series Operator's Manual, if required.
a. Open the door.
b. Lift up the measurement cartridge latch.
c. Insert the measurement cartridge.
Align the grooves on the sides of the cartridge with the grooves on
the system.
You must lock the cartridge in placed to successfully install the
NOTE:
cartridge.
d. Position the cartridge into the system, and then push firmly in and
upwards on the dot until you hear the cartridge lock in place.
e. Lower the latch to secure the measurement cartridge.
f. Install a new wash/waste cartridge into the system, and then push
firmly on the dot until the cartridge locks in place.
g. Close the door.
The system prepares the cartridges for use. The Wait screen
displays the time remaining until you can use the system. The
system displays the Analysis screen when the system is ready for
use.
Rev. C
and select the operating and reporting characteristics for
.
Installing and Relocating the Rapidpoint 400 Series System 393
, and touch the
12345
button.
Continue
button.
Continue