5. Loosen the two screws in the hinge brackets at the base of the display.
When reassembling, secure the display by pulling the hinge bracket
NOTE:
forward and torquing screws to 6-inch lb.
6. Remove the diskette drive. Refer to Replacing the Diskette Drive
Assembly on page 323.
7. Using the tilt display handle, pull the display forward.
8. Disconnect the display cable from the Main board.
9. Using a flat-blade screwdriver, press the spring pawl down while
pulling the display forward so that the display support slides out of the
slot in the interface wall.
Rev. C
.
Replacing Components 327