Bayer HealthCare RapidPoint 400 Series Service Manual page 445

flex circuit display cable,
drawing, 138
flow test, pump, 242
fluid detector 1 (FD1), mechanical
descriptions, 39
fluid detector 2 (FD2), mechanical
descriptions, 39
fluidic diagrams, 117 – 127
FOR DEMONSTRATION ONLY
mode, 419
determining, 420
setting the, 421
front door, illustration, 267
front view of the 400 system,
illustration, 265
front view of the 405 system,
illustration, 266
fuses,
(pack of 2), part number, 384
replacing, 306
G
generating trace log and sensor data
diskettes, 413
groups, adding to Rapidpoint, 435
H
halogen lamp. See replaceable
halogen lamp.
handle, location, 262
Hard 384
hard disk drive assembly, part
number, 384
hard drive cable, drawing, 133
hard drive,
location, 292
Rev. C
replacing, 334
hazards. See warnings.
I
IDEE ROM,
explanation of system
detecting, 420
in the demonstration measurement
cartridge, 421
illimination housing, illustration, 295
illumination housing assembly,
mechanical description, 57
illustrated parts lists, 259
illustrations,
AQC access panel, 395
CO-ox,
measurement components, 56
measurement system, 55
inboard 1 harness, drawing and wire
run list, 133
inboard 2 harness, drawing and wire
run list, 134
init. See cartridge initialization (init)
initialization and retrospective
calibration (retrocal) periods, 431
initialization calibration timeline
table, 431
initialization, cartridge,
Installation error message, 215
installing and configuring remote
access setup (RAS), 434
installing and relocating the
Rapidpoint 400 series system, 391
installing,
a new Rapidpoint 400 system, 414
rear cover, cartridge interface
Index 445