Replacing The Co-Ox Lamp - Bayer HealthCare RapidPoint 400 Series Service Manual

Replacing the CO-ox Lamp

sufficient time for it to cool.
Materials:
• CO-ox lamp
1. Turn off the power switch and disconnect the power cord from the
electrical outlet.
2. Disconnect the power cord from the rear panel of the system.
3. Locate the lamp on the rear panel of the system. Refer to the following
figure.
Replacing the CO-ox Lamp
4. Remove the old lamp and discard it.
Avoid touching the lamp with your fingers. Touching the glass
CAUTION:
may cause the lamp to deteriorate prematurely.
5. Install a new one.
6. Reconnect the power cord to the system.
7. Reconnect the power cord to the electrical outlet and turn the power
switch on.
After the Rapidpoint 400 series system title screen appears, the Wait
screen displays the time remaining until you can use the system. The
Analysis screen appears when the system is ready to analyze
samples.
308
Ensure that the lamp has been off for at least 5 minutes to allow
Rev. C