Bayer HealthCare RapidPoint 400 Series Service Manual page 257

1. If the system was turned off, turn the power switch on.
The power switch is located on the rear panel of the system.
The system displays the Rapidpoint 400 series system title screen.
2. If prompted, replace the cartridges. Refer to Replacing the
Measurement and Wash/Waste Cartridges in Section 3 in the
Rapidpoint 400 Series Operator's Manual.
The Wait screen displays the time remaining until you can use the
system. The Analysis screen appears when the system is ready to
analyze samples.
Rev. C Troubleshooting 257