Using Dhcp - Bayer HealthCare RapidPoint 400 Series Service Manual

h. If you want to change the name for the Rapidpoint 400 series
system, touch
i. Enter the name for the Rapidpoint 400 series system and touch the
Continue
j. Touch
k. Enter the IP addresses for the Rapidpoint 400 series system, the
default router port, and the network mask.
Ensure that you enter the IP addresses and the network mask in
NOTE:
the correct fields.
l. Touch the
m. At the Communications screen, touch the
n. The Wait screen appears while the system tests the connection
between the Rapidpoint 400 series system and the Rapidlink
system. At this time, the connection is unsuccessful.
o. When prompted that the connection was unsuccessful, touch the
Continue
4. Connect the network cable to the RJ-45 connector on the rear panel of
the Rapidpoint 400 series system.
5. At the Rapidlink workstation, enter the communication settings as
described in Appendix B of the Rapidlink Supervisor's Manual.
6. At the Rapidpoint 400 series system, touch the
from the Communications screen.
The Wait screen appears while the system tests the connection
between the systems.
7. Refer to the Rapidlink Supervisor's Manual to complete any additional
setup that may be necessary to operate the Rapidpoint 400 series
system with the Rapidlink program.

Using DHCP

Use this method if you are using dynamic host configuration protocol.
1. If prompted, enter your password, the service password, or the
password of the day.
Rev. C
Rapidpoint 400
button.
.
Enter IP Address
button.
Continue
button to display the Communications screen.
.
Continue
Continue
Connecting to a Computer System 403
button.
button to exit