The display cable fits tightly in the slot.
NOTE:
10. Remove the plastic grommet from the display cable slot.
11. Carefully pull the display cable and display cable plug through the slot
in the interface wall. Retain the cable plug.
12. Lift the display off the display pivot.
13. Install the new display module:
Leave some slack in the display cable between the display and the
NOTE:
interface wall to allow for movement of the display.
a. Reinsert the display cable through the slot in the interface wall and
reinsert the grommet.
CAUTION:
the spring pawl is incorrectly positioned when the display support is
inserted, the display support will jam.
b. Place the display module on the display pivot.
328
Ensure that the spring pawl is positioned forward in the slot. If
Rev. C