Select one of the following methods to configure the network connection:
•
enter IP addresses
•
using DHCP (dynamic host configuration protocol)
Materials:
•
twisted-pair cable with RJ-45 connector
•
Rapidlink Supervisor's Manual
Entering IP Addresses
Use this method if you are entering network IP addresses.
1. Obtain the following network information from your institution's
network administrator:
•
IP address for the Rapidpoint 400 series system
•
IP address for the Rapidlink workstation where you want to assign
the Rapidpoint 400 series system
•
IP address for the default router port assigned to the network
segment on which the Rapidpoint system is located
•
Network mask for the institution's network
2. If prompted, enter your password, the service password, or the
password of the day.
3. Select the communication settings at the Rapidpoint 400 series
system:
a. If prompted, enter your password, the service password, or the
password of the day.
b. Touch the
c. Touch
d. Touch
e. Touch
f.
Touch
g. The Configure CompleNet screen appears. The default name
(RP and the system serial number) appears in the name field.
402
button.
Status
.
Setup
Printer and Devices
.
Communications
and then touch
CompleNet
.
Configure
.
Rev. C