Bayer HealthCare RapidPoint 400 Series Service Manual page 331

6. Carefully lower the display until the hinge for the paper cover is
exposed.
7. Lift the paper cover off the hinge.
8. Install the new paper cover.
9. Reinstall the display support:
Ensure that the spring pawl is positioned forward in the slot. If
CAUTION:
the spring pawl is incorrectly positioned when the display support is
inserted, the display support will jam.
a. With the spring pawl positioned in the slot, use a flat-blade
screwdriver to press the spring pawl down, toward the front of the
system, and hold it down while inserting the display support
through the slot until it locks into place.
1 Flat-blade screwdriver holds the spring pawl in place
2 Spring pawl down toward the front of the system
3 Display support
If the spring pawl jams, position a screwdriver behind the spring pall
NOTE:
and push it forward while sliding the display support forward one tooth at
a time until correctly seated.
b. Using the tilt display handle, move the display back and forth to test
the position of the display support.
Rev. C Replacing Components 331