4. Remove the grounding tag.
1 Power entry module with switch
2 Rear interconnect board
3 Rear interconnect cable
4 DC power harness
5. Remove the rear interconnect board. Refer to Removing the Rear
Interconnect Board on page 343.
6. Remove the conductive tape from the sides of the power entry module.
7. With a screw driver, push down on the spring locks on the top and
bottom of the power entry module and push the power entry module out
of the frame.
8. Install the new power entry module:
a. Pass the power entry module cable harness through the slot.
b. Insert the power entry module into the frame until it locks in place.
Rev. C
Replacing Components 341