Printing Diagnostic Reports; Lamp On/Off - Bayer HealthCare RapidPoint 400 Series Service Manual

Test
temperature
lamp cal
wavelength cal

lamp on/off

sample chamber

Printing Diagnostic Reports

Use this procedure to print the following diagnostic reports:
• measurement
• sensors
• printer
• temperature
Some tests are will not be available on the Diagnostics screen
NOTE:
if the printer is out of paper.
1. Touch the
2. Touch
Sample Totals
The system cannot perform routine fluidic activities while you
CAUTION:
are at the Diagnostics screen or while you are performing diagnostic tests.
When you exit from the Diagnostics screen, the system may perform an
extended calibration before you can use the system.
3. Touch
Diagnostics
4. Enter the service password, or use the password of the day.
The Diagnostics screen appears.
Rev. C
Function
prints the temperature for various system components
tests and calibrates the halogen lamp
tests neon lamp operation and alignment
verifies proper operation of halogen lamp
moves the CO-ox sample chamber
button
Recall
.
.
.
Troubleshooting 231