Bayer HealthCare RapidPoint 400 Series Service Manual page 404

2. Select the communication settings at the Rapidpoint 400
seriessystem:
a. If prompted, enter your password, the service password, or the
password of the day.
b. Touch the
c. Touch
d. Touch
e. Touch
f. Touch
g. The Configure CompleNet screen appears. The default name
(RP and the system serial number) appears in the name field.
h. If you want to change the name for the Rapidpoint 400 series
system, touch
i. Enter the name for the Rapidpoint 400 series system and touch the
Continue
j. Touch
k. Touch the
l. At the Communications screen, touch the
m. The Wait screen appears while the system tests the connection
between the Rapidpoint 400 series system and the Rapidlink
system. At this time, the connection is unsuccessful.
n. When prompted that the connection was unsuccessful, touch
Continue
3. Connect the network cable to the RJ-45 connector on the rear panel of
the Rapidpoint 400 series system.
4. At the Rapidlink workstation, enter the communication settings as
described in Appendix B of the Rapidlink Supervisor's Manual.
5. At the Rapidpoint 400 series system, touch the
from the Communications screen.
The Wait screen appears while the system tests the connection
between the systems.
404
button.
Status
.
Setup
Printer and Devices
.
Communications
and then touch
CompleNet
Rapidpoint 400
button.
.
Use DHCP
button.
Continue
to display the Communications screen.
.
Configure
.
Continue
.
button.
button to exit
Continue
Rev. C