Bayer HealthCare RapidPoint 400 Series Service Manual page 338

e. Lift the power supply module up and out of the power module
frame.
2
1
1 DC power harness
2 Cable at J1
3 Plug to fan
4 Rear interconnect board cable
5 Cable at J3
6 Cable at J2
7 Screws under frame (4)
4. Install the new power supply module.
5. Reconnect cables to J1, J2, and J3.
6. Ensure that all cables are not crimped or pinched.
7. Reassemble in the reverse order. Refer to Installing the Rear Cover,
Cartridge Interface Assembly, and Power Module Assembly on
page 378.
338
3
4
5
6
7
Rev. C