Installing And Configuring Remote Access Setup (Ras) - Bayer HealthCare RapidPoint 400 Series Service Manual

Installing and Configuring Remote Access Setup (RAS)

Ensure that the modem is connected and turned on before
NOTE:
beginning this procedure.
1. From the Windows NT desktop, log on as Administrator.
2. From the Windows NT desktop Start menu, select
select
Control Panel
3. Double click the
4. After the Network applet starts, select the
Add.
5. At the Select Network Services dialog box, select
Service
6. When prompted, insert the Windows NT Workstation or the NT Server
CD (depending on the site configuration) into the CD-ROM drive.
7. When the NT startup window appears, close this window.
8. At the Windows NT Setup dialog box, select
9. At the Add RAS Device dialog box, ensure that the correct modem is
selected and then select
10. At the Remote Access Setup dialog box, select
11. At the Configure Port Usage dialog box, select
then select
12. Select
13. At the Network Configuration dialog box, ensure that the
TCP/IP
14. Select
15. At the RAS Server NetBEUI configuration dialog box, select
This computer only
16. Select
17. At the RAS Server TCP/IP configuration dialog box, select
This computer only
18. Enter the beginning and ending TCP/IP addresses provided by the
customer or use default addresses (2 addresses minimum).
434
.
Network
from the Network Service list and then select
.
OK
.
Network
check boxes are checked in the Server Setting frame.
next to the NetBEUI entry.
Configure
and then select
next to the TCP/IP entry.
Configure
and then select
icon.
Services
.
OK
OK.
Use static address pool
and then
Settings
tab and then select
Remote Access
.
OK
.
Continue
.
Configure
Receive calls only
NetBEUI
.
and
and
Rev. C