6. Remove the AutomaticQC frame assembly:
a. Remove the two thread-forming screws and washers from the
AutomaticQC frame assembly.
b. Pull the AutomaticQC frame assembly away from the wall
interface and lift it out of the system.
c. Disconnect the cable from the AutomaticQC frame assembly to
the outboard cable harness.
7. Reinstall the AutomaticQC frame assembly and the AutomaticQC
latch assembly.
8. Reinstall the cartridge interface assembly. Refer to Installing the Rear
Cover, Cartridge Interface Assembly, and Power Module Assembly on
page 378.
322
Rev. C