005-941 DADF Not Enough Documents Failure RAP
After all originals returned, shortage of documents detected.
Procedure
Follow instructions on the UI Screen
Launch Version
WorkCentre 5225, 5230
005-942 Doc fault loading on DADF RAP
Due to too many document sheets, no documents could not be fed.
Initial Actions
Reduce the number of sheets and repeat the operation.
Refer to BSD 5.2.
Procedure
Manually operate the Feed Head mechanism. The Feed Head mechanism moves smoothly.
Y
N
Replace the parts that are interfering with operation.
Execute
Component
Control[005-225 DADF Nudger Sensor]. Actuate the DADF Nudger Sen-
sor with paper. The display changes.
Y
N
Check the connections of
rectly.
Y
N
Connect
P/J788
and P/J786.
Check the wire between J788 and J786 for an open circuit or a short circuit (BSD 5.2
3/Flag
4). The wire between J788 and J786 is conducting without an open circuit or
a short circuit.
Y
N
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P786-7 (+) and GND (-) (BSD 5.2
The voltage is approx. +5VDC.
Y
N
Replace the DADF PWB
Measure the voltage between the DADF PWB P786-9 (+) and GND (-) (BSD 5.2
Actuate the DADF Nudger Sensor with paper. The voltage changes.
Y
N
Replace the DADF Nudger Sensor
Replace the DADF PWB
Execute
Component
Control[005-090]. The DADF Nudger Motor
Y
N
Check the connections of
rectly.
Y
N
Connect
P/J787
and P/J786.
Check the wire between J787 and J786 for an open circuit or a short circuit (BSD 5.2
5). The wire between J787 and J786 is conducting without an open circuit or a short
circuit.
A
February, 2008
2-89
P/J788
and P/J786.
P/J788
and
P/J786
(PL
15.3).
(PL
15.5).
(PL
15.3).
(PL
P/J787
and P/J786.
P/J787
and
P/J786
005-941, 005-942
are connected cor-
Flag
Flag
4).
Flag
3).
15.6) can be heard.
are connected cor-
Flag
Status Indicator Raps