User Manual
SURPASS hiD 6615 S223/S323 R1.5
3.1.12
A50010-Y3-C150-2-7619
Route-Map Configuration Mode
To open Route-map Configuration mode, use the following command. The prompt is
changed from SWITCH(config)# to SWITCH(config-route-map)#.
Command
route-map NAME {permit | deny}
<1-65535>
On Route-map Configuration mode, you can configure the place where information is
from and sent in routing table.
Tab. 3.12 shows a couple of important main commands of Route-map Configuration
mode.
Command
match
set
Main Commands of Route-map Configuration Mode
Tab. 3.12
Mode
Global
Opens Route-map Configuration mode.
Transmits routing information to specified place.
Configures router address and distance.
Description
Description
UMN:CLI
35