Managing Remote Syslog Servers; Viewing A List Of Remote Servers; Adding A Remote Server - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
• pattern is the pattern used to match the server's host name to the common name defined in the SSL
certificate
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.9.6

Managing Remote Syslog Servers

RUGGEDCOM ROX II can support up to 6 event message collectors, or remote Syslog servers. Remote Syslog
provides the ability to configure:
• IP address(es) of collector(s)
• Event filtering for each collector based on the event severity level
The following sections describe how to configure and manage remote Syslog servers:
• Section 3.9.6.1, "Viewing a List of Remote Servers"
• Section 3.9.6.2, "Adding a Remote Server"
• Section 3.9.6.3, "Deleting a Remote Server"
Section 3.9.6.1

Viewing a List of Remote Servers

To view a list of remote servers, type:
show running-config admin logging server
If remote servers have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin logging server
admin
logging
server 172.30.144.254
enabled
selector 1
no negate
facility-list [ all ]
!
!
!
!
If no remote servers have been configured, add servers as needed. For more information, refer to
Section 3.9.6.2, "Adding a Remote
Section 3.9.6.2

Adding a Remote Server

To add a remote server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the remote server by typing:
Managing Remote Syslog Servers
Server".
Chapter 3
Device Management
67