Advertisement
Setting the Communication Specifications
Setting the Communication Specifications
Change the settings of the controller communication specifications for non-procedural
communication with the external device.
Use USB cable or RS-232C cable to connect ZS-HL-N Series controllers to external devices. For USB
cable connection, install Smart Monitor ZS and USB driver beforehand. After installing Smart Monitor
ZS, USB ports are recognized as standard COM ports, and communication is achieved as with the RS-
232C. (Setting the communication specifications including baud rate is not necessary.) For details on
how to connect cable, refer to the User's Manual for each controller.
1.
Set the mode switch to "FUN".
2.
Select [System] - [Communication] - [Mode] menu.
3.
Select [non-procedural].
4.
For RS-232C cable connection, select [System] - [Communication] - [RS-232C]
menu to set the appropriate communication specifications for the external
device.
5.
Save the settings.
ZS-HL-N Series
2
Non-procedural Communication Command Reference
Advertisement
