Setting Measurement Conditions - Omron F150-2 Operation Manual

Setting Measurement Conditions

3-4

Setting Measurement Conditions

The F150 performs the calculations necessary for measurement
condition parameters according to the sampled images. Carry
out the operation in accordance with the messages displayed on
screen.
Procedure
1
Check that all of the registered sample images show either
OK or NG. If ?? appears as a memory number, parameter
calculation cannot be performed. Either set to OK or NG, or
clear that memory image.
2
Press the ESC Key. A confirmation message will be dis-
played.
2
3
Select Execute. Automatic setting will be performed. Wait
until the setting result is displayed.
3
Section 3-4
21