Table of Contents
Advertisement
Warning; This will disable the stacking hardware on member-1.
Are you sure you want to continue? (y/n):
Figure 92. Confirmation Prompt for the NO STACK ENABLE Command
8. Type Y to disable VCStack on the switch or N to cancel the procedure.
The switch displays the message in Figure 93.
awplus(config)#18:04:12 awplus VCS[2119]: Deactivating
Stacking Ports on stack member 1.
9. Press the Return key to re-display the Global Configuration mode
prompt.
10. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 94.
awplus(config)# exit
awplus#
Figure 94. Returning to the Privileged Exec Mode
11. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 95.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 95. Saving the Changes with the WRITE Command
If this is the initial management session, the switch automatically
creates the Default.cfg configuration file and stores your change in the
file.
12. Enter the REBOOT command to reboot the switch.
13. At the confirmation prompt, type "Y" for yes.
14. Wait three minutes for the switch to initialize its management software
and afterwards examine the Switch ID LED again. The switch is ready
for normal network operations as a stand-alone unit if its ID number is
"0." If the number is "1 or higher," repeat this procedure, being sure to
save the configuration change with the WRITE command in step 11.
SBx908 GEN2 Installation Guide for Stand-alone Switches
Figure 93. Disabling VCStack.
131
Advertisement
Table of Contents
