set vlanauthorization
set vlanauthorization
Enable or disable the use of the RADIUS VLAN tunnel attribute to put a port into a particular
VLAN based on the result of authentication.
Syntax
set vlanauthorization {enable | disable} [port-string]
Parameters
enable | disable
port‐string
Defaults
VLAN authentication is disabled by default.
Mode
Switch command, read‐write.
Examples
This example shows how to enable VLAN authentication for all Gigabit Ethernet ports:
C3(rw)-> set vlanauthorization enable ge.*.*
This example shows how to disable VLAN authentication for all Gigabit Ethernet ports on switch
unit/module 3:
C3(rw)-> set vlanauthorization disable ge.3.*
set vlanauthorization egress
Controls the modification of the current VLAN egress list of 802.1x authenticated ports for the
VLANs returned in the RADIUS authorization filter id string.
Syntax
set vlanauthorization egress {none | tagged | untagged} port-string
Parameters
none
tagged
untagged
port‐string
26-50 Authentication and Authorization Configuration
Enables or disables vlan authorization/tunnel attributes.
(Optional) Specifies which ports to enable or disable the use of VLAN
tunnel attributes/authorization. For a detailed description of possible port‐
string values, refer to "Port String Syntax Used in the CLI" on page 7‐1.
Specifies that no egress manipulation will be made.
Specifies that the authenticating port will be added to the current tagged
egress for the VLAN‐ID returned.
Specifies that the authenticating port will be added to the current
untagged egress for the VLAN‐ID returned (default).
Specifies that the port or list of ports. to which this command will apply.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 7‐1.