Clear Radius; Show Radius Accounting - Enterasys SecureStack C2 Configuration Manual

clear radius

Use this command to clear RADIUS server settings.
Syntax
clear radius [retries] | [timeout] | [server {index | all | realm {index | all}}]
Parameters
retries
timeout
server
index | all
realm
Mode
Switch command, read‐write.
Defaults
None.
Examples
This example shows how to clear all settings on all RADIUS servers:
C2(su)->clear radius server all
This example shows how to reset the RADIUS timeout to the default value of 20 seconds:
C2(su)->clear radius timeout

show radius accounting

Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
Syntax
show radius accounting [server] | [counter ip-address] | [retries] | [timeout]
Parameters
server
counter ip‐address
retries
timeout
Resets the maximum number of attempts a user can contact the RADIUS
server before timing out to 3.
Resets the maximum amount of time to establish contact with the RADIUS
server before timing out to 20 seconds.
Deletes server settings.
For use with the server parameter to clear the server configuration for all
servers or a specific RADIUS server as defined by an index.
Resets the realm setting for all servers or a specific RADIUS server as
defined by an index.
(Optional) Displays one or all RADIUS accounting server configurations.
(Optional) Displays counters for a RADIUS accounting server.
(Optional) Displays the maximum number of attempts to contact the
RADIUS accounting server before timing out.
(Optional) Displays the maximum amount of time before timing out.
SecureStack C2 Configuration Guide 18-7
clear radius