clear port counters
clear port counters
Use this command to clear port counter statistics for a port or range of ports.
Syntax
clear port counters [port-string]
Parameters
port‐string
Defaults
If no port‐string is specified, port counters are cleared for all ports.
Mode
Switch command, read‐write
Example
This example clears the port counters for ge.3.1.
C3(rw)->clear port counters ge3.1
show port cablestatus
Use this command to troubleshoot and locate faults in copper cable connections on a per port
basis. This command is only available on switch platforms that provide 1 Gigabit Ethernet RJ45
ports.
Syntax
show port cablestatus [port-string]
Parameters
port‐string
Defaults
If no port is specified, information about all ports will be displayed.
Mode
Switch command, read‐only.
Usage
For 1 Gigabit Ethernet RJ45 ports only, this command will display the status of the port's cable
connection (described in Table
port. If your switch platform does not support 1 GE RJ45 ports, this command will not be
available.
If no cable is attached to the port, the status will be "Open" and no length will be shown. If the
port is not a 1GE RJ45 port, the command will return a status of "Not Supported."
7-6 Port Configuration
(Optional) Specifies the port or range of ports to clear port counter
statistics.
(Optional) Specifies the port or ports to show status for.
7‐3 below), and the approximate length of the cable attached to the