Configuring Priority To Transmit Queue Mapping; Purpose; Commands; Show Port Priority-Queue - Enterasys D-Series Cli Reference Manual

Configuring Priority to Transmit Queue Mapping

Example
This example shows how to reset fe.1.11 to the default priority:
D2(rw)->clear port priority
Configuring Priority to Transmit Queue Mapping

Purpose

To perform the following:
• View the current priority to transmit queue mapping of each physical port.
• Configure each port to either transmit frames according to the port priority, set using the set
port priority command described in "set port priority" on page 12‐2, or according to a priority
based on a percentage of port transmission capacity, assigned to transmit queues using the set
port txq command described in "set port txq" on page 12‐7.
• Clear current port priority queue settings for one or more ports.

Commands

For information about...

show port priority-queue

set port priority-queue
clear port priority-queue
show port priority-queue
Use this command to display the port priority levels (0 through 7, with 0 as the lowest level)
associated with the current transmit queues (0 being the lowest priority) for each selected port. A
frame with a certain port priority is transmitted according to the settings entered using the set
port priority‐queue command described in "set port priority‐queue" on page 12‐5.
Syntax
show port priority-queue [port-string]
Parameters
port‐string
Defaults
If port-string is not specified, priority queue information for all ports will be
displayed.
Mode
Switch command, read‐only.
12-4 Port Priority and Rate Limiting Configuration
fe
.1.11
(Optional) Displays the mapping of priorities to transmit queues for one
or more ports.
Refer to page...
12-4
12-5
12-6