Configuring Irdp; Purpose; Ip Irdp Enable - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Configuring IRDP

Purpose

To enable and configure the ICMP Router Discovery Protocol (IRDP) on an interface. This protocol
enables a host to determine the address of a router it can use as a default gateway. It is disabled by
default.
Commands
For information about...

ip irdp enable

ip irdp maxadvertinterval
ip irdp minadvertinterval
ip irdp holdtime
ip irdp preference
ip irdp broadcast
show ip irdp
ip irdp enable
Use this command to enable IRDP on an interface. The no form of this command disables IRDP on
an interface.
Syntax
ip irdp enable
no ip irdp enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to enable IRDP on the VLAN 1 interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip irdp enable
(su)‐>router(Config‐if(Vlan 1))#
Configuring IRDP
Refer to page...
20-37
20-38
20-38
20-39
20-39
20-40
20-40
SecureStack C2 Configuration Guide 20-37