Table of Contents
Advertisement
set console baud
Example
This example shows how to display all console settings:
B3(su)->show console
Baud
------
9600
set console baud
Use this command to set the console port baud rate.
Syntax
set console baud rate
Parameters
rate
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the console port baud rate to 19200:
B3(su)->set console baud 19200
Activating Licensed Features
In order to enable the B3 advanced features, such as Policy, you must purchase and activate a
license key. If you have purchased a license, you can proceed to activate your license as described
in this section. If you wish to obtain a permanent or evaluation license, use the Enterasys
Customer Portal or contact the Enterasys Networks Sales Department.
License Key Field Descriptions
When Enterasys supplies a license, it will be sent to you as a character string similar to the
following:
INCREMENT policy 2006.0127 27-jan-2011 0123456789AB 0123456789AB
The contents of the six fields, from the left, indicate:
3-26 Basic Configuration
Flow
Bits
StopBits
-------
----
----------
Disable
8
1
Sets the console baud rate. Valid values are: 300, 600, 1200, 2400, 4800, 5760,
9600, 14400, 19200, 38400, and 115200.
Note: All members of a stack must be licensed in order to support licensed features in a stack
environment. If the master unit in a stack has an activated license, all member units also must have
an activated license in order to operate. If the master unit in a stack does not have an activated
license, then the licensed functionality will not be available to member units, even if they have
licenses installed.
Parity
------
none
Advertisement
Table of Contents
