Ip Rip Receive Version; Ip Rip Authentication-Key - Enterasys SecureStack C2 Configuration Manual

ip rip receive version

Use this command to set the RIP version(s) for update packets accepted on the interface. The no
form of this command restores the default version of the RIP router update packets that are
accepted on the interface.
Syntax
ip rip receive version {1 | 2 | 1 2 | none}
no ip rip receive version
Parameters
1
2
1 2
none
Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Defaults
None.
Example
This example shows how to set the RIP receive version to 2 for update packets received on the
VLAN 1 interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip rip receive version 2

ip rip authentication-key

Use this command to enable or disable a RIP authentication key (password) for use on an
interface. The no form of this command prevents RIP from using authentication.
Syntax
ip rip authentication-key name
no ip rip authentication key
Parameters
name
Defaults
None.
Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Specifies RIP version 1. This is the default setting.
Specifies RIP version 2.
Specifies RIP versions 1 and 2.
Specifies that no RIP routes will be processed on this interface.
Specifies the password to enable or disable for RIP authentication.
ip rip receive version
SecureStack C2 Configuration Guide 17-5