Set Rmon Capture - Enterasys Matrix 2G4072-52 Configuration Manual

11.2.4.34 set rmon capture

Use this command to configure an RMON capture entry, or to enable or disable an existing entry.
set rmon capture index {channel [action {lock | wrap}] [slice slice] [loadsize
loadsize] [offset offset] [asksize asksize] [owner owner]} | {enable | disable}
Syntax Description
index
channel
action lock | wrap
slice slice
loadsize loadsize
offset offset
asksize asksize
owner
enable | disable
Command Defaults
•
•
•
•
•
Specifies a buffer control entry.
Specifies the channel to which this capture entry will be
applied.
(Optional) Specifies the action of the buffer when it is full
as:
•
•
(Optional) Specifies the maximum octets from each
packet to be saved in a buffer. (default: 100)
(Optional) Specifies the maximum octets from each
packet to be downloaded from the buffer (default: 100)
(Optional) Specifies that the first octet from each packet
that will be retrieved.
(Optional) Specifies that the requested maximum octets
will be saved in this buffer.
(Optional) Specifies the name of the entity that
configured this entry.
Enables or disables an existing RMON capture entry.
If not specified, action defaults to lock.
If not specified, offset defaults to 0.
If not specified, asksize defaults to 1 (which will request as many octets as
possible)
If slice and loadsize are not specified, 100 will be applied.
If owner is not specified, it will be set to monitor.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Logging And Network Management Command Set
lock - Packets will cease to be accepted
wrap - Oldest packets will be overwritten
Configuring RMON
11-95