Show Ip Igmp Interface - Enterasys SECURESTACK C3 Configuration Manual

show ip igmp interface

Parameters
version
Defaults
None.
Mode
Interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the IGMP version to version 1 on VLAN 1:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip igmp version 1
show ip igmp interface
Use this command to display information about one or more IGMP routing interfaces.
Syntax
show ip igmp interface [vlan vlan-id]
Parameters
vlan vlan‐id
Defaults
If not specified, information will be displayed for all VLANs configured for IGMP routing.
Mode
Any router mode.
Example
This example shows how to display IGMP routing information for VLAN 1:
C3(su)->router#show ip igmp interface vlan 1
Vlan 1 is Admin UP
Vlan 1 is Oper UP
IGMP is configured via the Switch
IGMP ACL currently not supported
Multicast TTL currently defaults to 1
IGMP Version is 2
Query Interval is 125 (secs)
Query Max Response Time is 100 (1/10 of a second)
Robustness is 2
Startup Query Interval is 31 (secs)
Startup Query Count is 2
Last Member Query Interval is 10 (1/10 of a second)
Last Member Query Count is 2
13-12 IGMP Configuration
Specifies the IGMP version number to run on the router. Valid values are
1, 2, or 3.
(Optional) Displays information for one or more VLANs.