7.3.4.2
set vlan egress
Use this command to add ports to the VLAN egress list for the device, or to prevent one or more
ports from participating in a VLAN. This determines which ports will transmit frames for a
particular VLAN.
set vlan egress vlan-list port-string [untagged | forbidden | tagged]
Syntax Description
vlan-list
port-string
untagged |
forbidden |
tagged
Command Defaults
If untagged, forbidden or tagged is not specified, the port will be added to the
VLAN egress list as tagged.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to add Fast Ethernet ports 5 through 10 in module 1 to the egress list of
VLAN 7. This means that these ports will transmit VLAN 7 frames as tagged
Matrix(rw)->set vlan egress 7 fe.1.5-10
Specifies the VLAN where a port(s) will be added to the
egress list.
Specifies one or more ports to add to the VLAN egress list
of the specified vlan-list. For a detailed description of
possible port-string values, refer to
(Optional) Adds the specified ports as:
•
untagged — Causes the port(s) to transmit frames
without an IEEE 802.1Q header tag.
•
forbidden — Instructs the device to ignore dynamic
requests (either through GVRP or dynamic egress) from
the port(s) to join the VLAN and disallows egress on that
port.
•
tagged — Causes the port(s) to transmit 802.1Q tagged
frames.
Matrix DFE-Platinum and Diamond Series Configuration Guide
VLAN Configuration Command Set
Configuring the VLAN Egress List
Section
4.1.1.
:
7-31