Paging Through The Vlan List; Static Vlan Egress Configuration Screen - Enterasys SmartSwitch 6000 User Manual

Static VLAN Egress Configuration Screen

8.3.5

Paging Through the VLAN List

To display additional VLANs that do not display in the current VLAN List as shown on the screen,
use the NEXT or PREVIOUS commands located at the bottom of the screen, as follows:
NOTE: The NEXT and PREVIOUS fields will only display if there are further VLAN List
entries to page through.
1. To display the next screen, use the arrow keys to highlight NEXT. Press ENTER to view the
entries on the next screen.
2. To display the previous screen, use the arrow keys to highlight PREVIOUS. Press ENTER to
view the entries on the previous screen.
8.4 STATIC VLAN EGRESS CONFIGURATION SCREEN
When to Use
To set the type of egress (tag status) for each or all ports associated with a VLAN selected on the
Static VLAN Configuration screen. The ports can be set using the following selections:
•
UNTAGGED – sets the port to transmit frames without a tag header. This setting is usually set
to configure a port connected to an end user device.
•
TAGGED – sets the port to transmit frames with a tag header to associate the frame
with the VLAN. This setting is usually to configure a port as a trunk port to another switch.
•
NO – sets the port so it does not transmit frames (tagged or untagged) of the VLAN.
How to Access
Use the arrow keys to highlight the line item with the VLAN ID of interest on the Static VLAN
Configuration screen and press ENTER. The Static VLAN Egress Configuration screen,
Figure 8-4, displays.
8-10 802.1Q VLAN Configuration Menu Screens