Show Spantree Tctrapsuppress; Set Spantree Tctrapsuppress - Enterasys SECURESTACK C3 Configuration Manual

Example
This example shows how to reset the backup root function to disabled on SID 2:
C3(rw)->clear spantree backuproot 2

show spantree tctrapsuppress

Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
Syntax
show spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the status of topology change trap suppression:
C3(rw)->show spantree tctrapsuppress
Topology change Trap Suppression is set to enabled

set spantree tctrapsuppress

Use this command to disable or enable topology change trap suppression on Rapid Spanning Tree
edge ports.
Syntax
set spantree tctrapsuppress {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Disables or enables topology change trap suppression.
show spantree tctrapsuppress
SecureStack C3 Configuration Guide 9-23