Show Spantree Tctrapsuppress; Set Spantree Tctrapsuppress - Enterasys C3G124-24 Configuration Manual

show spantree tctrapsuppress

show spantree tctrapsuppress
Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
Syntax
show spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the status of topology change trap suppression:
C3(rw)->show spantree tctrapsuppress
Topology change Trap Suppression is set to enabled

set spantree tctrapsuppress

Use this command to disable or enable topology change trap suppression on Rapid Spanning Tree
edge ports.
Syntax
set spantree tctrapsuppress {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read-write.
Usage
By default, RSTP non-edge (bridge) ports that transition to forwarding or blocking cause the
switch to issue a topology change trap. When topology change trap suppression is enabled, which
is the device default, edge ports (such as end station PCs) are prevented from sending topology
change traps. This is because there is usually no need for network management to monitor edge
port STP transition states, such as when PCs are powered on. When topology change trap
suppression is disabled, all ports, including edge and bridge ports, will transmit topology change
traps.
13-24 Spanning Tree Configuration
Disables or enables topology change trap suppression.