Configuring Static Unicast Addresses - Enterasys Vertical Horizon VH-2402S2 Configuration Manual

Configuring Static Unicast Addresses

Use the Static Unicast Address Table Configuration screen to manually
configure host MAC addresses in the unicast table. You can use this
screen to associate a MAC address with a specific VLAN ID and switch
port as shown below.
VID
------------------------------------------------------------
Sorted by : VID + MAC
VID : 1
MAC : 00-00-00-00-00-00
[Show]
Use <TAB> or arrow keys to move. <Enter> to select
Figure 2-53. Static Unicast Address Table Configuration
Parameter
VID
MAC Address
Unit
Port
Status
[Show]
[More]
[Set]
68 VH-2402S2 User Interface
Vertical Horizon Stack Local Management
Static Unicast Address Table Configuration
MAC Address
[More]
Description
The VLAN group this port is assigned to.
The MAC address of a host device attached to this switch.
The switch unit the host device is attached to.
The port the host device is attached to.
The status for an entry can be set to:
Permanent:
DeleteOnReset:
Invalid:
DeleteOnTimeOut: This entry is currently in use and will remain
Other:
Displays the static address table sorted on VID as the primary key
and MAC address as secondary key.
Scrolls through entries in the static address table.
Adds the specified entry to the static address table, such as
shown in the following example:
VID : 1
Unit : 1
Status : Permanent
Unit Port
VID : 1 MAC
Unit : 1 Port : 1
Status : Permanent
[Set]
<OK>
This entry is currently in use and will remain
so after the next reset of the switch.
This entry is currently in use and will remain
so until the next reset.
Removes the corresponding entry.
so until it is aged out. (Refer to Address Table
Aging Time on page 66.)
This entry is currently in use but the
conditions under which it will remain so differ
from the preceding values.
MAC : 00-00-00-e8-34-22
Port : 1
Status
: 00-00-00-00-00-00
VH-2402S2