Configuring Snmp Target Addresses; Purpose; Commands; Show Snmp Targetaddr - Enterasys D-Series Cli Reference Manual

Parameters
targetParams
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear SNMP target parameters named "v1ExampleParams":
D2(su)->clear snmp targetparams v1ExampleParams

Configuring SNMP Target Addresses

Purpose

To review and configure SNMP target addresses which will receive SNMP notification messages.
An address configuration can be linked to optional SNMP transmit, or target, parameters (such as
timeout, retry count, and UDP port) set with the set snmp targetparams command (page 7‐24).

Commands

For information about...

show snmp targetaddr

set snmp targetaddr
clear snmp targetaddr
show snmp targetaddr
Use this command to display SNMP target address information.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Parameters
targetAddr
volatile | nonvolatile
| read‐only
Defaults
If targetAddr is not specified, entries for all target address names will be displayed.
Specifies the name of the parameter in the SNMP target parameters table
to be cleared.
(Optional) Displays information for a specific target address name.
(Optional) When target address is specified, displays target address
information for a specific storage type.
Configuring SNMP Target Addresses
Refer to page...
7-25
7-26
7-28
Enterasys D-Series CLI Reference 7-25