Removing And Installing The Piston Of The Brake Caliper Of The Fs-Iii Brake - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
1.2 Removing and installing the piston of the
brake caliper of the FS-III brake
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
♦ Piston jig - T10145-
Removing:
– Press the piston out of the brake caliper using compressed air.
Insert wooden plate so that the piston is not damaged.
– Remove gasket ring with disassembly wedge - 3409- .
When removing, make sure that the cylinder surface is not dam‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
aged.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Installing:
– Clean piston and gasket ring with white spirits and dry off.
– Before inserting the piston and gasket ring, thinly coat with
lithium grease - G 052 150 A2- .
– Insert sealing ring into the brake caliper.
– Position the new protective cap with the outer sealing lip on
the piston.
154
Rep. gr.47 - Brakes - hydraulics