Engine, exhaust system and fuel
Bonnet
Opening the bonnet
Before opening
›
Make sure the windscreen wiper arms are folded
down onto the windscreen.
›
Keep everyone away from the engine compart-
ment.
Opening
›
Pull the release lever underneath the dash panel.
›
Open the bonnet.
›
Remove the bonnet stay from the holder and insert
the end of the stay into the opening in the bonnet.
Closing
›
Lift the bonnet.
›
Unhook the bonnet stay and insert it into the hold-
er.
›
Fold the bonnet down and release it with a dis-
tance of 30 cm remaining.
›
Check that the bonnet is closed.
›
Release the lock.
Engine, exhaust system and fuel ›
NOTICE
Do not press down on an unclosed bonnet.
▶
Open and close the flap again.
▶
Engine oil
Checking the fill level and topping up
Test conditions
✓ The vehicle is on a horizontal surface
✓ The parked engine is warm
Checking the level
›
Wait a few minutes for the engine oil to flow back
into the oil sump.
›
Remove the dipstick and wipe with a clean cloth.
›
Insert the dipstick as far as it will go and pull it out
again.
›
Read the oil level and push the dipstick back in
again.
NOTICE
Risk of damage to the engine and the exhaust sys-
tem!
The oil level must not be outside the marked range.
▶
If it is not possible to top up the engine oil or if the
oil level is above the marked range, do not continue
driving. Stop the engine and seek the help of a spe-
cialist garage.
Do not use any oil additives.
▶
Consumption
Depending on driving style and operating conditions,
the engine consumes some oil, up to 0.5 l/1000 km.
Consumption may be higher over the next 5000 km.
Refilling
›
Unscrew the cover of the engine oil filler opening.
›
Top up the oil to the correct specification in 0.5 li-
tre portions.
›
Check the oil level.
›
Screw on the cover of the engine oil filler opening.
Bonnet
75
The oil level must be
within the marked range.