Fujitsu MB90390 Series Hardware Manual page 27

Reference: Main changes (Rev.2 → Rev.3)
Page
Table 28.5-1 Command Sequence Table
1st bus write cycle is changed in Address of Auto-select.
(FxAAA → FxAAAA)
Notes is changed.
563
(• The addresses Fx in the table mean FF, FE, FD, FB, FA and F9 for 3M-bit Flash Memory and FF, FE, FD,
FC, FB, FA, F9 and F8 for the 4M-bit Flash Memory. Use these addresses as the access target bank values for
operations. → • The addresses Fx in the table mean FF, FE, FD, FB, FA and F9 for 3M-bit Flash Memory.
Use these addresses as the access target bank values for operations.)
■ Suspending Erasing of Flash Memory Sectors is changed.
(after a maximum period of 15µs has elapsed. → after a maximum period of 20µs has elapsed.)
582
("Sector Erase Suspend command should be entered more than 20µs after Sector Erase command or Sector
Erase Restart command is issued." is added)
● Input of a hardware reset (RST) is changed.
584
Table 29.1-1 Pins Used for Fujitsu Standard Serial Onboard Programming
593
Additional information of VCC is changed.
Table A-1 I/O Map (1/6)
Register of Address 00000D
606
(Analog Input Enable 1/ ADC Select → Analog Input Enable 1)
Table A-1 I/O Map (2/6)
Address 000028
(UART2 → Reserved)
Register and Abbreviation in Address 00002F
607
(Serial I/O Prescaler/Edge Selector → Serial I/O Prescaler)
Register of Address 000030
(External Interrupt Enable → External/DTP Enable Register)
Table A-1 I/O Map (3/6)
Register and Peripheral in Address 00003B
(ROM Correction Control Status 1 → Program address detection control status register 1)
608
(ROM Correction 1 → Program Address Detection 1)
Register of Address 00003E
(PPG2 and PPG3 clock select register → PPG2/PPG3 clock control register)
Table A-1 I/O Map (4/6)
Initial value of Address 00005F
609
(0XXXXXX0
Table A-1 I/O Map (5/6)
Initial value of Address 00006F
(XXXXXXX1
610
Register and Peripheral in Address 00009E
(ROM Correction Control Status 0 → Program address detection control status register 0)
(ROM Correction 0 → Program Address Detection0)
* is added.
Changes (For details, refer to main body.)
is changed.
H
to 00002B is changed.
H H
is changed.
H
is changed.
H
is changed.
H
→ 0XXXXX00
)
B B
is changed.
H
→ XXXXXX+*1
)
B B
are changed.
H
are changed.
H
are changed.
H
xxiii