Fujitsu MB90390 Series Hardware Manual page 23

Reference: Main changes (Rev.2 → Rev.3)
Page
Figure 19.3-1 Configuration of the Serial Mode Control Register (UMC) is changed.
(UMC2 is deleted.)
(000028
315
H
Serial Output enable is changed.
(SOT0,1,2 → SOT0, SOT1)
Table 19.3-1 Function of Each Bit of the Serial Control Register
316 Function of bit1 and bit0 is changed.
(Note is deleted.)
Figure 19.3-2 Configuration of the Status Register (USR) is changed.
(USR2 is deleted.)
317
(000029
H
Figure 19.3-3 Input Data Register (UIDR) and Output Data Register (UODR) is changed.
319
(00002A
H
Figure 19.3-4 Configuration of the Rate and Data Register (URD) is changed.
(URD2 is deleted.)
320
(00002B
H
■ Transfer Data Format is changed.
(UMC0, 1, 2 → UMC0, UMC1)
327
(SIN0, 1, 2 → SIN0, SIN1)
(SOUT0, 1, 2 → SOUT0, SOUT1)
Summary of 19.8 Parity Bit is changed.
(URD0, 1, 2 → URD0, URD1)
328
(UMC0, 1, 2 → UMC0, UMC1)
CHAPTER 20 UART2, UART3
337
Note is added.
Table 20.1-1 UART2, UART3 Functions (2/2)
339 Function of LIN bus options is changed.
((UART3) / ICU3 (UART2, MB90V390HA/MB90V390HB only) is added.)
341
Table 20.1-4 UART2, UART3 Interrupt and EI
■ Block Diagram of UART2, UART3 is changed.
342
(• LIN Synch Break Generation Circuit is added.)
347 Table 20.3-1 UART2, UART3 Pins is changed.
Figure 20.3-1 Block Diagram of UART2, UART3 Pins is changed.
348
(Note:UART2 is functionally the same as UART3, except the registers and pin numbers is added.)
349 Figure 20.4-1 UART2, UART3 Registers is changed.
Figure 20.4-2 Configuration of the Serial Control Register (SCR2/SCR3) is changed.
350
(SCR2: 0035D9
Figure 20.4-3 Configuration of the Serial Mode Register (SMR2/SMR3)
SMR2: 0035D8
Serial data output enable bit of LIN-UART is changed.
(disable SOT3 pin (high Z) → General purpose I/O port)
352
(enable SOT3 pin (TxData) → LIN-UART serial data output pin)
Serial clock output enable bit of LIN-UART is changed.
(External Serial Clock Input → General purpose I/O port or LIN-UART clock input pin)
(Internal Serial Clock Output → Serial clock output pin of LIN-UART)
Figure 20.4-4 Configuration of the Serial Status Register (SSR2/SSR3) is changed.
354
(SSR2: 0035DB
Changes (For details, refer to main body.)
is deleted.)
is deleted.)
is deleted.)
is deleted.)
is added.)
H
is added.
H
is added.)
H
2
OS is changed.
xix