Rep 1.9 Rear Face Up Cover Assembly; Rep 1.10 Interlock Cover - Xerox DocuPrint N2125 Service Manual

REP 1.9 Rear Face Up Cover Assembly

Parts List on PL 1.3
Removal
Switch off the power and disconnect the Power Cord.
1. Open the Rear Cover Assembly (REP
2. Release the Pivot Arm from the Rear Face Up Cover Assembly
the cover removed for clarity.)
3. Close the Rear Cover Assembly.
4. Open the Rear Face Up Cover Assembly.
5. Push the right hinge pin to the left (as viewed from the rear) until the hinge pin is free of
the Rear Cover.
6. Remove the Rear Face Up Cover Assembly.
Figure 1 Rear Face Up Cover Assembly
Replacement
1. Reinstall the components in the reverse order.
Repair-Adjustment
REP 1.9, REP 1.10
WARNING
1.8).
(Figure 1). (The art shows

REP 1.10 Interlock Cover

Parts List on PL 7.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Rear Cover Assembly
2. Remove the one screw that secures the Stopper to the printer
3. Remove the two screws that secure the Interlock Cover to the printer
4. Remove the Interlock Cover from the printer
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-10
WARNING
(REP 1.8).
(Figure
(Figure 1).
Figure 1 Interlock Cover
1).
(Figure 1).
Initial Issue
DocuPrint N2125