Display Saved-Configuration - 3Com 5500-EI PWR Reference Manual

return

display saved-configuration

Syntax
display saved-configuration [ unit unit-id ] [ by-linenum ]
View
Any view
Parameters
unit unit-id: Specifies the unit ID of a switch. With this keyword-argument combination specified, this
command can display the initial configuration file of the specified unit.
by-linenum: Displays configuration information with line numbers.
Description
Use the display saved-configuration command to display the initial configuration file of a switch.
Note that:
If the switch starts up without a configuration file, the system will display that no configuration file
exists upon execution of the command.
If you have saved configuration after the switch starts up, the command displays the last saved
configuration.
Related commands: save, reset saved-configuration, display current-configuration.
Examples
# Display the initial configuration file of the current switch.
<Sysname> display saved-configuration
#
sysname sysname
#
password-control login-attempt 3 exceed lock-time 120
#
radius scheme system
#
domain system
#
vlan 1
#
interface Vlan-interface1
ip address 192.168.0.30 255.255.255.0
#LOCCFG. MUST NOT DELETE
#
ntp-service unicast-server 192.168.0.52
ntp-service unicast-server 192.168.0.65
#
interface Aux1/0/0
#
1-6