Lan Settings - Keysight FieldFox A Series User Manual

System Settings
System Configuration
— Use the
— Press
— Press

LAN Settings

Configure the LAN settings to be used to communicate with the Data Link
Software and connect to the FieldFox for remote SCPI operation. Learn more
about Data Link at: www.keysight.com/find/fieldfoxsupport.
Table 26-1 LAN LEDs (N995xA, N996xA
number prefixes ≥5607)
LAN LEDs (N995xA, N996xA, and applies to: N991xA/2xA/3xA units with serial number
prefixes ≥5607) )
When FieldFox is connected to the LAN, the flashing LAN LEDs have the following
definitions:
Green: Flashing indicates packets are being transferred.
Yellow:
— Flash, pause = 10 Mbit link speed
— Flash, flash, pause = 100 Mbit link speed
— Flash, flash, flash, pause = 1 GBit link speed
How to configure LAN settings
The first three 'Current...' settings can NOT be edited.
— Press System 7.
— Then System Configuration.
— Then More.
Keysight N9927-90001 User's Guide
arrows or numeric keypad to edit that field.
Cancel or Done
Done to exit the Date and Time settings. The readout in the
upper-right corner of the FieldFox screen will update accordingly.
when the edits are complete.
applies to: N991xA/2xA/3xA units with serial
, and
535