USB
The USB interface requires no front panel configuration. The USB operation and
configuration is supported by the version of VISA and SICL IO libraries on your PC.
Before connecting the USB cable, ensure that the I/O software has been
NOTE
installed on your PC.
Refer to
Keysight IO Libraries software. If you have installed other I/O software, refer to
the documentation that accompanies the software.
1 After the I/O software has been installed on your PC, connect the N432A to
2 The PC will confirm the hardware connection.
3 The Found New Hardware Wizard will automatically start and guide you
Figure 1-1
Keysight N432A Installation Guide
"Remote Interface Configurations"
your PC using the supplied Type A – Mini 5-pin USB cable.
through the configuration of the N432A as a USB device. Click
the software automatically and accept all defaults to complete the installation.
Found New Hardware Wizard
Getting Started
on page 38 for the information on
1
to install
Next
39