Table of Contents
Advertisement
1
Getting Started
1 After I/O software is installed on your computer, connect your EPM Series
2 The PC confirms the hardware connection.
3 The Found New Hardware Wizard automatically starts and guides you through
Figure 1-1
If you installed Keysight IO Libraries software, you also installed low-level
NOTE
drivers. Therefore, you do not need to insert the CD when Found New Hardware
Wizards requests you to do so.
4 When the Wizard has completed configuring the power meter, a Assign USB
5 You can use Connection Expert in the IO Libraries Suite to check instrument
6 Now you can use various programming environments to control the power
40
power meter to your PC using the supplied Type A - Mini 5 pin USB cable.
configuring the power meter as a USB device (see
install the software automatically, accept all defaults to complete the
installation.
Found New Hardware Wizard
device alias window appears on your PC. If required, enter an Alias name to
easily identify the power meter.
identification.
meter. For an overview about programming the power meter via USB, refer to
the connectivity guide and the programming guide.
Figure
Keysight N1913/1914A Installation Guide
1-1). Click Next to
Advertisement
Table of Contents
