Canon imagePRESS 1135 Series Service Manual page 499

4
Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Installing the ITB cleaning blade > When reusing the blade (the number of fed sheets is 500,000
3) After rotating the blade by 180 degrees vertically, install the blade with its surface side facing
upward while referring to the steps 4 and later.
NOTE:
Be sure to install the blade so that its unused edge [B] is on the front side.
5) When tightening the screw, hold the cleaning blade and temporary tighten it in the following
procedure.
4 Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Installing the ITB cleaning blade > When reusing the blade (the number of fed sheets is 500,000
4) When installing the cleaning blade, align the both sides [A] of cleaning cover with the
both sides [B] of cleaning blade, and push it to rear [C] part to install.
[A]
[B]
F-4-496
6) When tightening the screw, hold the cleaning blade and firmly tighten it in the following
procedure.
F-4-498
[C] part
[A]
[B]
4-235
[A]
[B]
F-4-497
F-4-499
4-235