Canon imagePRESS 1135 Series Service Manual page 465

4
Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Installing the drum cleaning blade > When reusing the blade (the number of fed sheets is 500,0
■ When reusing the blade (the number of fed sheets is 500,000 or less)
1) Pull out the blade, and rotate it by180 degrees horizontally while keeping the blade with its surface side facing upward.
NOTE:
Change the direction of the blade by rotating it to make the used edge [A] come to the rear side and the unused edge [B] come to the front side.
2) Check that the surface side of the removed blade is facing upward (judge it by the stamp of the lot No.).
<Blade with its surface side facing upward.>
<Blade with its surface side facing downward.>
4 Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Installing the drum cleaning blade > When reusing the blade (the number of fed sheets is 500,0
[B]
[A]
F-4-410
[A]
[B]
[B]
[A]
[A]
[B]
F-4-411
CAUTION:
• If the front and back sides are mistaken, image failure may
occur due to toner slipping.
• Be sure to install the blade with its surface side facing
upward.
F-4-413
4-201
F-4-412
4-201